robu-1

Driver of a stepper motor DM542

$37
1480 грн

Buy

Buy

Category:

Product Description

Description

Fully digital stepper driver implemented using an advanced 32-bit DSP control algorithm based on the latest motion control technology. It is easy to use and can be used for 2-phase and 4-phase motors (Nema 17-Nema 34). Auto-identification of motor parameters and auto-tuning function provide quick determination of optimal operating conditions with different motors. Thanks to this, the engine runs smoothly, with less heat generation and operating noise.

The driver operates with a voltage of 20-50 V DC and can provide a maximum winding current of up to 4.2 A. To set the required current parameters and step division, use the table with a combination of DIP switches on the case.

Parameters

  • 15 modes step division from 1: 2 to 1: 128;
  • working voltage: 24-50VDC;
  • working current: up to 4.2A;
  • signal frequency - up to 300 kHz
  • opto-isolated control inputs STEP, DIR, ENABLE;
  • selection of the STEP / DIR or CW / CCW operating mode;
  • protection against short circuit of the stepper motor windings;
  • back EMF protection of SM;
  • mode of holding the stepper motor rotor.

Related Products